Ozone Generator

The Ozone Generator Model OG250 is a highly efficient, Fused Quartz Crystal Tube, High Frequency Cold Plasma / Cold Corona ozone generator utilizing the state of art Inverter based on MOSFET / IGBT. Breakthrough technology has been applied to the OG250 allowing it to operate from a 230 Volt AC that is easily available. The OG250 unit comes complete with a built-in Air Pump, Quartz Glass Ozone Cell and Power Supply, Gas termination. The Ozone Generator is a true 5/25 Grams per Hour Cold Corona / Cold Plasma Ozone Generator used for various application requiring Ozone Supply.

The Ozone Generator is extremely easy to operate. Simply connect the power cord of the Ozone Generator to a 230 Volt AC socket and switch on the supply. The Status Lamp will flash at regular interval indicating that Ozone Generator is ready. Now rotate the rotary switch Ozone ON to ON position. First the air pump will be ON and then Corona discharge will start. The ozone will come out from the OZONE OUT. This can be directly used for Water Treatment by injecting in to a Water Tank or Air disinfection by injecting in to Air Duct. A unique circuit design allows the unit to be extremely compact, lightweight, powerful and efficient.

The High Voltage power supply is built using Micro Controller and MOSFET / IGBT. The operating frequency is around 6 kHz, which gives maximum Ozone output for particular Cell design. The complete circuit is protected for short circuit and over Voltage. The Over temperature Protection works for the electronic component and Ozone cells. A powerful and fast Micro Controller controls the entire operation including protection, and no operator attention is required. As safety interlock switches off the high voltage power supply, when the door is opened.

The High voltage is generated with a High quality Ferrite Core transformer. The transformer is designed to take 25% extra load if required. The primary and secondary are wound with Electrolytic grade copper wire to minimize the copper and skin losses. The transformer is enclosed in powder coated sheet metal tank and it is oil cooled for high efficiency. The oil cooling also offers protection to High voltage coil from moisture and dust.

The Ozone Cells are fabricated from high-grade Stainless Steel (316), which offers good resistance to Ozone. The dielectric used is 99.99 % pure Quartz Glass which has excellent dielectric properties. The heat loss is also minimum at designed power. The ends of electrode are sealed with Silicone Rubber 'O' rings, which is again ozone resistance. All the pipe terminations are machined out of stainless steel Grade 316, and piping is made of Silicon / Teflon / Plastics material. The ozone cells are air cooled by three heavy-duty fans, and keep the cell temperature below ozone destruction.

The Ozone Generator OG250 has two Air Pumps (only in OG250). These pumps are diaphragm type and rated for continuous duty. The pump delivers about 16 Liters of Air per minute at a pressure of 10.5 PSI. If higher ozone out put is required then Feed Gas can be Oxygen, which will increase the ozone output by 4-5 times (in OG250). The OG250 has provision for oxygen feed also.